CUDA Series 2840 Operator's Manual page 29

3. Remove the two wire nuts from the power leads to
disconnect the leads from the motor, and discon-
nect the conduit from the motor housing.
4. Remove the four 1/2" bolts from the skimmer
assembly mounting plate to remove the skimmer
assembly from the machine.
5. Remove the two screws from the center of the
skimmer disk to detach the disk from the skimmer
assembly. To remove the disk, disengauge it from
the center pin, then slide it down.
Screws
Oil Skimmer
Motor
Wire Nuts
Nut
Cuda 2840 Operator's Manual 8.930-370.0 - AU
6. Remove the three screws from the skimmer motor
mounting plate to remove the motor from the
skimmer assembly.
7. Reassemble the skimmer assembly and replace it
on the machine. Assembly is the reverse of
removal.
Maintenance
29