Maintenance
Timers and Switches on the Control Panel
Required Tools and Equipment
•
• 5/16" wrench or socket
•
• 1/2" wrench or deep socket
•
• small phillips-head screwdriver
•
• small flat-head screwdriver
Replacement Procedure
1. Disconnect power to the machine.
2. Remove the control panel face plate (four 10/32"
screws).
3. Disconnect the wiring harness from the rear of the
face plate.
4. Remove the knob from the timer you wish to
remove.
5. Remove the two screws, retaining nut, and o-ring
that hold the timer switch to the control panel.
Screws
6. Detach the power leads from the timer.
7. Attach the power leads to the new timer.
28
8. Install the new timer. Installation is the reverse of
Oil Skimmer Motor
Required Tools and Equipment
Replacement Procedure
1. Disconnect power to the machine.
2. Remove two 5/16" screws to remove the skimmer
Retaining
Nut
Knob
Cuda 2840 Operator's Manual 8.930-370.0 - AU
removal.
•
5/16" wrench or socket
•
1/2" wrench or socket
•
small phillips-head screwdriver
motor cover.
Screws (Two on
Each Side)
Slide Cover
Toward Rear
to Remove