Filtration System (Optional) - CUDA Series 2840 Operator's Manual

Operations
NOTE: If your machine is equipped with the optional
automatic water fill feature, the sump will
automatically fill when the water level drops below the
lower low water proximity switch.
Proximity
Switches
Float Rod
Filtration and Sump Sweep Systems
(Optional)
The optional filtration and sump sweep systems reduce
or eliminate the need to manually clean out the sump.
The filtration system continuously filters solid particles
from the wash solution, and you can use the sump
sweep system to periodically remove waste build up
from the bottom of the sump chamber.
18

Filtration System (Optional)

The filtration system uses a filter canister with a nylon
or polyester felt filter bag to continuously filter solid
particles from the wash solution. The filter system
includes pressure gauges which allow you to monitor
the condition and performance of the filter bag inside
the canister. Under typical operating conditions, the
inlet and outlet pressure gauges read approximately 45
psi. As the filter bag becomes soiled, the outlet
pressure decreases. If the difference between the inlet
and outlet pressure is 15 psi or greater, stop the
machine and clean or replace the filter bag (See
Cleaning the Filters).
WARNING: Operating the machine with a clogged
Float
filter system could damage the filter bag. STOP
THE MACHINE IMMEDIATELY if the difference
between the inlet and outlet pressure is 15 psi or
greater.
AVERTISSEMENT: Utiliser la machine alors que le
système de filtration est obstrué risquerait d'endo
mager le sac du filtre. ARRÊTER IMMÉDIATEMENT
LA MACHINE si la pression de sortie chute en deçà
de 15 psi.
Cuda 2840 Operator's Manual 8.930-370.0 - AU