Turntable Motor - CUDA Series 2840 Operator's Manual

Turntable Motor

Required Tools and Equipment
• • 5/16" wrench or socket
• • 1/8" hex key
• • medium phillips-head screwdriver
Replacement Procedure
1. Disconnect power to the machine.
2. Remove the main electrical panel cover (eight
screws; use a 5/16" wrench or socket). The
turntable motor assembly is located just below the
electrical panel.
3. Remove the drive pulley access plate.
Drive Pulley
Access
To remove the plate, remove the two screws using
a 5/16" wrench or socket, then slide the plate
toward the rear of the machine through the slot in
the housing.
4. Remove the compression spring from the motor
assembly using a 9/16" wrench and socket.
Compression
Spring
5. Push the motor assembly toward the front of the
machine, then reach into the drive pulley access
hole with your fingers to free the chain from the
Cuda 2840 Operator's Manual 8.930-370.0 - AU
drive pulley. Take care not to let the chain slip into
the wash chamber. Use a piece of wire to secure
the chain while you replace the motor.
Motor Pulley
6. Disconnect all power leads from the motor, taking
care to mark them for reassembly.
7. Raise the motor and bracket to remove the
assembly from the pivot pin.
8. Use a 3/32" hex key to remove the pulley and
steam shield disk from the drive motor shaft, then
remove the four mounting screws holding the
motor to the mounting bracket.
Hex Bolt
9. Install the new motor. Installation is the reverse of
removal.
Maintenance
Mounting
Screws
Steam
Shield
Disk
27