Changing Password - Siemens SITRANS F M MAG 5000 Operating Instructions Manual

Commissioning

6.4 Changing password

Setup mode is a read and write mode. The pre-selected settings can be scanned and
changed. Access to the setup mode is password-protected. The factory set password is
1000.
Access to a submenu in the setup menu is gained by pressing the lock key
up key
and return to operator menu No. 1.
6.4 Changing password
The setup menu is password-protected in order to ensure that only authorized personnel can
make any changes in transmitter settings.
Change password as follows:
1. Press top up key
2. Enter password.
3. Use forward key
4. Press lock/unlock key
5. Use select key
6. Press lock/unlock key
7. Press top up key
See change password diagram.
The factory-set password is 1000, but it can be changed to any value between 1000 and
9999.
Factory setting of password can be re-established as follows:
1. Switch off power supply.
2. While pressing top up key
3. Release top up key
42
briefly to return to the previous menu. Press longer (2 sec.) to exit the setup menu
for 2 sec.
or backward key
to unlock password.
and change key
to confirm new password.
two times to exit setup mode.
after 10 sec.
to reach password menu.
to change password.
- switch on power supply.
Operating Instructions, 12/2013, A5E02338368-002
. Press the top
SITRANS F M MAG 5000/6000