Hrg Router Mode - Comtech EF Data CRS-170A Installation And Operation Manual

CRS-170A L-Band 1:1 Redundancy Switch MN/CRS170A.IOM
Cables and Connections Revision 14
5.4.2.2

HRG Router Mode

Figure 5-22 shows the block diagram and cabling example for an HRG 1:1 redundant configuration using
the Gigabit Ethernet Interface in Router Mode. This configuration requires no cabling kit – you must use
user-provided Ethernet cables and Layer 2 switch for direct connection to the modem via any one of the
two, four, or eight available RJ-45 Traffic Ethernet ports.
Both details in Figure 5-22 show use of 'GE1' Traffic Ethernet port for the example. Any
single Traffic Ethernet port may be used.
HRG Block Diagram – Gigabit Ethernet 1:1 Router Mode
Figure 5-22. HRG Gigabit Ethernet 1:1 Cabling Example – Router Mode
5–26