Table of Contents
Advertisement
Place fibre with protection sleeve in sleeve heater, straighten the optic
fibre lightly and make sure protection sleeve's left end is aligned with and
heater slot's left end , as shown in figure 26.Then close heater cover.
Select "Sleeve Heating Mode" and the heating parameters.(if it is the same
with last time, you may skip this step).
Close the heater cover or enter the heating key "
heat indication light is on. Press heat shrinkage key "
heating, the heating will be canceled.
When heating is completed (about 23 s), the heat indication light is off.
Users need to immediately turn on the heater cover and remove the optical
fibre, as shown in Figure 27.(Note: Do not use your hand to touch the
heated protection sleeve to prevent being burned.)
Check the finished sleeve, if it is qualified, place the sleeve in the cooling
pans to let it cool down; if the finished sleeve has bubbles or dust inside, it
is suggested to repeat the operation.
November 2018
Figure 26. Place Fibre with Protection Sleeve.
Figure 27. The Effect of Heating
" to start heating. The
" in the process of
Page
25
Advertisement
Table of Contents
