Table of Contents
Advertisement
For these last fibre types, user must do "arc calibration" before use
it.
Splice operate mode
Automatic or Manual.
Splice program No.
For each fibre type there are 30 groups of pre-set parameters.
These groups can be edited by the user.
Edit splice program
Edit splice parameters under the current number of program.
Clean Arc time
Cleaning Arc means cleaning exquisite dust on the fibre surface by
short-time arc. The duration ranges from 0 to 1 second.
Surface angle threshold
An error message is displayed if the head face angle of either left or
right side of fibre exceeds the limit. The setting range is 0-5°.
Fibre angle threshold
An error message is displayed if the clamp angle of the two fibres
spliced exceeds the angle Limit. The setting range is 0-4°.
Align offset threshold
An error message is displayed if the misalignment of the two fibres
spliced exceeds the misalignment limit. The setting range is 0.0-1.5
μm.
Loss threshold
An error message is displayed if the estimated splice loss exceeds
the loss limit. The setting range is 0 - 0.2 db.
Compensation arc time
Splice loss may be improved by compensative arc in some cases.
Fibre Alignment Mode
Cladding align or core align can be set.
Fast splice mode
If it is "on" accelerates alignment.
Forced Splice Mode
If it is "on" it forces fibre splice.
16
Page
November 2018
Advertisement
Table of Contents
