Table of Contents
Advertisement
Battery Charge
►
When connected with exterior adapter, the battery pack will be charged.
The charging time varies with the remaining capacity. The longest charging
time is 3 hours.
Battery alarm
►
When the remaining capacity of the battery pack is lower than 10% or it is
unable to guarantee the normal work of the fusion splicer, it will show alarm
information on the monitor. Users shall immediate charge it or use adapter
to supply power.
Warnings
►
When using the battery pack, follow the instructions below.
Please charge fully for the first use.
Please check the battery capacity before use. If the battery capacity is
low or it has shown under-voltage alarm, please charge immediately.
Please do not charge or store battery pack under high temperature or
direct sunlight in order to avoid aging.
Please charge the battery fully for long time storage.
Battery pack is easily depleted. Repeated charge and discharge will
make the charging ability of it decreased. When the battery is full of
electricity but can only be used for short time, it is time to replace with
designated type of battery timely.
2.2
Startup and Shutdown
To start the equipment, press the power button "
operation panel will turn red and the buzzer will buzz. The monitor showcases the
fibre observation interface after all motors are reset to their initial positions, as
shown in Figure 2. Then the power supply mode will be automatically recognized.
If you use battery pack for power supply, the interface will showcase its
remaining power. The monitor will indicate abnormality information if it finds out
that the system is abnormal when start the equipment.
November 2018
". The power LED on the
7
Page
Advertisement
Table of Contents
