Washing And Cleaning; Storage - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

The safety device operates based on the inputs of sensors WB1 and WB2 and the position of sensor plate
A (Figure 60).
1. When sensor plate A is at the position of the upper sensor WB2: the guard mesh is open, the
sensor WB2 light is on and electrically controlled functions, such as sawing and splitting, are
off.
2. When sensor plate A is at the position of the lower sensor WB1: the guard mesh is closed, the
sensor WB2 light is off and the sensor light WB1 is on, and electrically controlled functions,
such as sawing and splitting, are operable.

5.9. Washing and cleaning

Any loose dirt and sawdust can be removed from the machine with pressurised air, for example. The
machine can also be washed with a high-pressure washer as long as the water jet is not aimed directly at
the bearings or electrical equipment.
Always ensure that the machine and the working area are sufficiently clean during operation. The
machine must always be cleaned after use. Clean the machine at suitable intervals and always before
storing the machine for a prolonged time. After washing, the firewood processor must be lubricated
according to the instructions in Section 6.

5.10. Storage

Although the machine is intended for outdoor use, it should be covered and stored in a sheltered location
or indoors. Before prolonged storage, the machine must first be cleaned, then washed according to the
instructions in Section 9 and lubricated according to Section 6.
Note! The out-feed conveyor belt may shrink and tighten while in storage due to humidity. For this
reason, the out-feed conveyor must be folded into the transport position while the machine is in
storage.
Hakki Pilke 43 Pro
44 / 48
Figure 60.
Translation Version 6-2018