Resplitting Or Splitting Without Cutting; Replacing The Splitting Blade; Adjusting The Stroke Length Of The Splitting Motion - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

4.4.2.
1. Raise the protective cover of the cutting and splitting groove.
2. Place the log you want to split in the splitting groove.
3. Close the protective cover of the cutting and splitting groove.
4. Activate the splitting cycle with button B (Figure 11).
The above procedure can be used to split wood without cutting it as necessary.
4.4.1.
Exercise extreme caution when handling the blade, and wear protective gloves.
1. Pull handle B (Figure 22)
to make it possible to
lower the splitting blade
to the lowest possible
position.
(Note! the
conveyor is A in Figure 22)
2. Lower the splitting blade
to the lowest possible
position. If
remove pieces of wood
from under the blade.
3. Turn off the machine and
disconnect it from the
power source.
4. Lift the splitting blade out
of its slot.
5. Install a new splitting
blade by reversing the
above steps.
4.4.2.
In the Hakki Pilke 43 firewood processor, the splitting cylinder is controlled electrically with sensors A and
B in Figure 23. The stroke length of the splitting cylinder can be adjusted as follows:
1. Shut down the machine and disconnect it from its power sources.
2. Remove the machine's cover plate, as shown in Figure 23.
Hakki Pilke 43 Pro

Resplitting or splitting without cutting

Replacing the splitting blade

out-feed
necessary,

Adjusting the stroke length of the splitting motion

28 / 48
Figure 22.
Translation Version 6-2018