After Use - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

The out-feed conveyor has an automatic debris removal device. It separates debris and sawdust from the
processed firewood.
The following things significantly affect the operation of the debris removal device: the angle of the out-
feed conveyor, the speed of the belt and the distance of separation plate D (Figure 24) from the upper
roller of the conveyor. In other words, the debris separation result is better the steeper the angle
(however, no more than 40 degrees), the lower the speed and the longer the distance between
separation plate D and the upper roller. The distance of separation plate D is optimised at the factory in
conjunction with the testing of the machine. However, the adjustment can be changed with adjustment
screw C (2 pcs, Figure 24), if necessary.
The optimal speed for the belt can be determined by trying different settings. The split logs should only
just pass over the plate.
Note! The operator must ensure that the distance between the debris discharge opening and the pile of
debris that accumulates under it is at least 30 cm.

4.6. After use

1. After you have finished making firewood, stop the out-feed conveyor, shut down the machine and
remove the firewood from the splitting groove and conveyor.
2. Check that the machine has not been damaged.
3. Place the out-feed conveyor into a position that allows the conveyor and firewood processor to be
moved safely off the processed firewood.
4. Clean the machine.
Hakki Pilke 43 Pro
30 / 48
Figure 24.
Translation Version 6-2018