Placing The Out-Feed Conveyor In The Operating Or Transport Position - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

3.1.2.
Place the out-feed conveyor in
the operating position
follows:
1. Ensure that there is
sufficient room for
opening the out-feed
conveyor.
2. Turn off the machine.
3. Keep lock A (Figure 7)
open and lower the out-
feed conveyor to its
lowest position with the
winch.
If you are using a larger
conveyor (as shown in
Figure 8), lower the out-
feed conveyor
hydraulically with
control lever E (Figure
10).
Note! Leave sufficient
clearance
30 cm) for the discharge
opening of
conveyor.
4. Turn the upper section
of the conveyor to the
operating position with
the handle(s) B (Figure
8). Note! If necessary,
have two people on
either side of the
conveyor to lift it!
5. Lock the upper section of
the conveyor into place
with latch C and cotter
pin D, as shown in Figure
9.
6. Turn the support bar (E
in Figure 9) of the
conveyor belt to the
Hakki Pilke 43 Pro

Placing the out-feed conveyor in the operating or transport position

as
(approx.
the
12 / 48
Figure 7.
Figure 8.
Figure 9.
Translation Version 6-2018