Replacing And Tensioning The Out-Feed Conveyor Belt; Replacing The Out-Feed Conveyor Plates; Lubrication - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

Firewood processor

Hide thumbs

Table Of Contents

Table of Contents

5.4.2.

The instructions for tensioning and aligning the out-feed conveyor are presented in Section 4.4.

Replace the out-feed conveyor belt as follows:

1. Pull out the pin locking the conveyor in place and lower the conveyor to the ground.

2. Shut the machine down and disconnect it from its power sources.

3. Move the belt joint to the start of the conveyor.

4. Fold the conveyor, but do not place the belt support in the transport position. This will allow the

belt to hang loose.

5. Disconnect the joint by opening the bolts.

6. Remove the old belt.

7. First, insert the new belt under the folded conveyor (bottom opening) from the end of the

conveyor with the plates facing downwards. Feed the belt in until you can pull it out from the

other end of the conveyor. Pull out a length of approx. 60 cm.

8. Push the other end of the belt into the upper section of the folded conveyor (top opening) from

the end of the conveyor. Feed it in until you can connect the joint.

9. Pull the excess belt to the start of the conveyor.

10. Lower the conveyor back to the operating position and tension the belt.

The belt is at the correct tension when its middle section is raised approx. 15 cm when the conveyor is

in the operating position. An excessively tight belt may be damaged more easily, and it places

unnecessary strain on the conveyor bearings.

5.4.3.

The out-feed conveyor plates can be replaced by disconnecting the bolt joints (3 x M8) fastening the

plates and replacing the plates with new ones. It is recommended that you move the belt into a position

that puts the plate to be replaced above the conveyor. Shut the machine down and disconnect it from the

power source for the duration of the procedure.

5.5. Lubrication

All of the firewood processor's lubrication points, which require Vaseline, have been labelled. There are

33 lubrication points, presented in the figures below. Note! Take care when applying grease to dustproof

bearings!

1. Grease nipple of the out-feed conveyor's turning joint (1 pc) in Figure 42. (every 50 hours)

2. Grease nipples of the height adjustment device of the splitting blade (2 pcs) in Figure 43.

(every 50 hours)

3. Bearing nipples of the out-feed conveyor's lower roller (2 pcs) in Figure 44. (every 200 hours)

4. Grease nipples of the guide plate (2 pcs, every 50 hours) and the grease nipple of the in-feed

conveyor drive roller in Figure 45. (every 200 hours)

5. Grease nipples of the cutting cylinder (2 pcs) in Figure 46. (every 50 hours)

6. Grease nipples of the splitting cylinder's pin (2 pcs) in Figure 47. (every 50 hours)

7. Grease nipples of the wood measuring device (2 pcs) and one of the guard's two grease

nipples in Figure 48. (every 50 hours)

8. Grease nipples of the out-feed conveyor's swivel cylinder (2 pcs) in Figure 49. (every 50 hours)

9. Grease nipples of the log press (7 pcs) in Figure 50. (every 50 hours)

10. The guard's second hinge nipple in Figure 51. (every 50 hours)

11. Grease nipples of the measuring device (2 pcs) and the guide plate (2 pcs) in Figure 52. (every

50 hours)

Hakki Pilke 43 Pro