Tractor Drive - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

G. Out-feed conveyor belt control lever
 Upper position: The out-feed conveyor belt rotates forwards
 Middle position: The out-feed conveyor belt does not move
 Lower position: The out-feed conveyor belt rotates backwards (momentary use for
removing a blockage, for example)
H. Speed adjuster for the out-feed conveyor belt
 The belt's speed decreases when the adjuster is turned towards the closed position and
vice versa
I. Accessory valve when a larger conveyor is used (otherwise empty as shown in Figure 10)
 Used for controlling accessories (HakkiFeed) Note! Do not use the log lifter or other cylinders
without lock valve 50030918, which is available as an accessory!
3.2.1.
A tractor-powered firewood processor is connected to
the tractor's three-point lifting devices and cardan
shaft. To connect the machine to the cardan shaft,
you have to move protective cover A of the socket
and angle gear into a position where it covers the
socket (in combi models).
Connecting the cardan shaft is a task for only one
person. When connecting the machine to the tractor,
there must be no one in the tractor cabin, so as to
prevent any accidental contact with the controls.
Check all the connecting devices of the tractor and
the firewood processor before connecting them.
Never use faulty equipment.
The 3-pin power cable for the electric controls is
connected to the tractor's 12 V socket for a work
machine (Figure 14).
When using the cardan shaft, observe any instructions provided by the manufacturer of the shaft. The
machine requires 15 kW of power, which must be taken into account with regard to the capacity of the
cardan shaft. A suitable cardan shaft is of power class four. Make sure that the connected shaft is locked
to the splined shaft of the multiplier gear. Connect the chain that prevents the turning motion of the
guard to hole B. Hang the cardan shaft from hook C when the machine is not being operated and when it
is disconnected from the tractor. Finally, ensure that all connections are safe and secure. Never use a
damaged or unprotected cardan shaft.
Note! Tractor-powered machines must be attached to the lifting equipment of the tractor.
Note! The starter (Figure 15) only functions when the machine is powered by electricity.
Hakki Pilke 43 Pro

Tractor drive

Translation
16 / 48
Figure 12.
Version 6-2018