Controls - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

Note! Do not stand on the out-feed conveyor! Do not use the winch if the belt is worn!

3.2. Controls

Names and functions of the controls in Figure 10
A. Feed assist speed control; only affects the automatic feed speed during splitting when the
feed assist mechanism is in use (switch B) (see Section 4.3.1).
B. Feed assist mechanism switch
- Switch in position 1: the feed assist mechanism is turned on: continues to feed for the
duration of the splitting cycle
- Switch in position 0: the feed assist mechanism is turned off – no automatic feed.
C. Control lever for guide plates that guide falling wood pieces (see
- Upper position: AUTO: the guide plates are in automatic mode, i.e. the plates go up and
down automatically according to the movement of the saw bar
Hakki Pilke 43 Pro
14 / 48
Figure 10. Controls
Translation
Section 4.3.5)
Version 6-2018