Conveyor Maintenance; Replacing And Tensioning The In-Feed Conveyor Belt - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

5.4. Conveyor maintenance

5.4.1.
Replace the in-feed conveyor belt as
follows:
1. Shut the machine down and
disconnect it from its power
sources.
2. Raise and lock the in-feed
conveyor into the transport
position. (See Section 3.1.1.)
3. Move the belt joint to a
suitable height.
4. Disconnect the joint by using
pliers, for example, to pull out
pin A (Figure 38), which holds
the joint together.
5. Remove the old belt.
6. Slide the new belt under the
table from the side of the in-
feed conveyor's drive roller
until you can pull the belt out
from the other end (C).
7. Lead the rest of the belt
under the log press, around
the rear roller and, finally,
behind the conveyor.
8. Connect the joint by inserting
pin A into the joint.
9. Turn the conveyor back to the
operating position
tension the belt.
10. Finally, adjust the belt to the
correct tension and to run
straight with the help of the
adjustment nuts D.
The belt is at the correct
tension when its middle
section is raised approx. 5 cm
when the conveyor is in the
operating position.
excessively tight belt may be
damaged more easily, and it
places unnecessary strain on
the bearings of the conveyor.
Hakki Pilke 43 Pro

Replacing and tensioning the in-feed conveyor belt

and
An
Translation
36 / 48
Figure 38.
Figure 39.
Figure 41.
Figure 40.
Version 6-2018