Saw Chain Lubrication - Hakki Pilke 43 Pro Instructions For Assembly, Operation And Maintenance

5.6. Saw chain lubrication

The cutting chain is automatically lubricated
whenever it rotates. In other words, oil is fed
to the cutting chain hydraulically from the
tank with a controlled pump, and the pumping
motion occurs when the saw begins to run.
You can adjust the amount of cutting chain oil
fed to the chain with the help of hex socket
screw A (Figure 54), i.e. the amount of oil
decreases when the screw is tightened and
vice versa.
The factory setting for screw A (Figure 54) is
3.5 turns towards the open position from the
closed position. Increase or decrease the
amount as necessary according to the type of
wood, air temperature and type of oil.
Before starting, always check that oil is fed to
the chain by rotating the chain without
sawing wood.
You can monitor the cutting chain's oil level
through opening A (Figure 55).
Add cutting chain oil as follows:
1. Remove fastening screw B and
open the guard with handle C
(Figure 55).
2. Remove the canister's rubber
fastening, then the filler cap and
the empty canister.
3. Install a new, full canister in place
by following these steps in reverse
order. Check that the hoses and
the pump outputs are free of air
bubbles.
section.)
Hakki Pilke 43 Pro
(See the following
40 / 48
Translation
Figure 54.
Figure 55.
Version 6-2018