Table of Contents
Advertisement
4.7
CHANGING THE OIL OF THE MULTIPLIER GEAR
1. Run the machine for a while in order
to warm up and mix the oils.
2. Turn off the tractor and remove the
cardan shaft from the multiplier gear
splined shaft.
3. Open breather cap A in Figure 30 (this
will allow the oil to drain more easily)
as well as drain cap B, and drain the oil
into a suitable container.
4. Close drain cap B.
5. Add 0.09 litres of appropriate oil to
the angle transmission through the
breather opening. (The multiplier gear
is small, so approx. 1 dl of oil is suffi-
cient).
6. Finally, close breather cap A (Figure
30).
4.8
CONVEYOR MAINTENANCE
Replacing and tightening the in-feed conveyor belt
Replace the in-feed conveyor belt as
follows:
1. Shut the machine down and discon-
nect it from its power sources.
2. Raise and lock the in-feed conveyor
into the transport position. (See Sec-
tion 2.3).
3. Move the belt joint to a suitable
height.
4. Disconnect the joint by using pliers, for
example, to pull out pin A (Figure 31)
that holds the joint together.
HAKKI PILKE RAVEN 33
31
Figure 31.
TRANSLATION
Figure 30.
VERSION 1
Advertisement
Table of Contents
