General Installation Information; Connection Scheme - Krautzberger M-10 Operating Instructions Manual

Automatic spray gun M -10
CAUTION!
Risk of injury due to sharp edges!
Sharp edges and pointed corners can cause abrasions and cuts on the skin.
Note:
– Proceed cautiously when working on or near sharp edges and pointed corners.
– Wear protective gloves, if in doubt.
5.2

General installation information

Adhere to the following general information for the installation:
n Only carry out the installation and start of operation according to the steps described in this
operating manual.
n Make sure that the utilised hose lines meet the requirements for pressure, chemical and
mechanical loads.
n Only operate the automatic spray gun after proper fastening on a suitable carrier design.
n Make sure that the connected compressed air is oil-free and free of solid matter.
n Operate the automatic spray gun with processed, dried compressed air (air quality pursuant to
DIN ISO 8573-1: grade 4).
n Vibration and recoil forces may occur on the automatic spray gun during operation. Ensure
sufficient fastening.
n Never point the compressed air at living beings.
5.3

Connection scheme

The connection diagram shown here must be seen as an example. Other connection options are
possible depending on the installation situation or the configuration of the automatic spray gun.
■ 200-0142
ENGLISH
GB–17