Table of Contents
Advertisement
Automatic spray gun M14
6 Installation
6.1
Safety
Personnel:
n
Specialised personnel
Protective equipment:
The selection of the protective equipment depends on the installation conditions on site. Always
observe the applicable country-specific safety, accident prevention, occupational safety, and envi-
ronmental protection regulations for the proper selection of the protective equipment.
WARNING!
Danger of injury due to improper assembly!
Recoil forces and vibrations occur during the operation. In case of insufficient fastening, the
automatic spray gun may come loose and cause serious injuries or property damage.
Note:
–
Ensure sufficient fastening of the automatic spray gun.
CAUTION!
Risk of injury due to sharp edges!
Sharp edges and pointed corners can cause abrasions and cuts on the skin.
Note:
–
Proceed cautiously when working on or near sharp edges and pointed corners.
–
Wear protective gloves, if in doubt.
6.2
General installation information
Adhere to the following general information for the installation:
n
Only carry out the installation and start-up in accordance with the steps described in this oper-
ating manual.
Ensure that the utilised hose lines meet the requirements for pressure, chemical and mechan-
n
ical loads.
Only operate the automatic spray gun after proper fastening on a suitable carrier construction.
n
Make sure that the connected compressed air is oil-free and free from solid matter.
n
Operate the automatic spray gun with processed, dried compressed air (air quality pursuant to
n
DIN ISO 8573-1: quality class 4).
n
Vibration and recoil forces may occur on the automatic spray gun during the operation.
Ensure sufficient fastening.
n
Never point the compressed air at living beings.
■ 200-0153
ENGLISH
GB–17
Advertisement
Table of Contents
