General Information About The Start-Up; Shutting Down - Krautzberger M-10 Operating Instructions Manual

Automatic spray gun M -10
WARNING!
Hearing damage due to excessive noise exposure!
Depending on the operating conditions, the sound pressure of the device/machine may cause
hearing damage.
Note:
– Take suitable action to reduce the impact of the existing sound pressure level. The owner
is responsible for the type and implementation of suitable measures, which may depend
on the local conditions.
6.2

General information about the start-up

Adhere to the following general information for the start-up:
n Only carry out the commissioning of the automatic spray gun pursuant to the steps described
in these operating instructions.
n Check the material and compressed air hose lines for damage and tight fit before each use.
n Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations for the area of use for the automatic spray
gun.
Do not use sharply abrasive, chemically aggressive, very hot or very cold spray media without
n
first consulting with and receiving approval from Krautzberger GmbH.
n Adhere to the spray media manufacturer's safety data sheets.
n Only operate the automatic spray gun while adhering to the values specified in (
12 'Technical data' on page 43).
n Only operate the automatic spray gun after proper fastening on a suitable carrier design.
n Do not hold the automatic spray gun in your hand during operation.
n Never point the compressed air at living beings.
n Adhere to the operating manuals for the respective components
6.3

Shutting down

6.3.1 Temporary shut-down
End the spray procedure by switching off the control air (connection "St").
The atomiser air (connection "Z") is automatically closed in the automatic spray gun.
6.3.2 Long-term shut-down
1. Close the air supply for control air and atomiser air (
on page 17).
2. Close the material supply and switch off the pump if necessary.
3. If necessary, clean the spray gun (
■ 200-0142
Ä Chapter 5.3 'Connection scheme'
Ä Chapter 7.3 'Cleaning' on page 27).
ENGLISH
Ä Chapter
GB–23