Automatic spray gun MC1
CAUTION!
Risk of injury due to sharp edges!
Sharp edges and pointed corners can cause abrasions and cuts on the skin.
Note:
–
Proceed cautiously when working on or near sharp edges and pointed corners.
–
Wear protective gloves, if in doubt.
6.2
General installation information
Adhere to the following general information for installation:
n
Only carry out installation and commissioning in accordance with the steps described in this
operating manual.
n
Ensure that the utilised hose lines fulfil the requirements with respect to pressure, chemical,
and mechanical loads.
n
Only operate the automatic spray gun after proper fastening on a suitable carrier construction.
n
Make sure that the connected compressed air is oil-free and free from solid matter.
n
Operate the automatic spray gun with processed, dried compressed air (air quality pursuant to
DIN ISO 8573-1: quality class 4).
n
Vibration and recoil forces may occur on the automatic spray gun during the operation.
Ensure sufficient fastening.
n
Never point the compressed air at living beings.
■ 200-0413
ENGLISH
GB–17