Talkswitch TS-350i Start Manual page 13

Default Ring Tone
To change the Default Ring Tone for the IP phone:
• Press the
• Press the digit, or move the cursor to 3. Phone Settings using the Down softkey
and press the Select softkey.
• Press the digit, or move the cursor to 2. Ring Settings using the Down softkey and
press the Select softkey.
• Press the digit, or move the cursor to 1. Default Ring Tone using the Down
softkey and press the Select softkey.
• Select the Ring Tone using the Down softkey. Press
the Play softkey to hear the selected tone.
• Press the Select softkey to change to the selected
Ring Tone.
• To configure another parameter, press the Back
softkey to continue or press the
the configuration menu.
Line Ring Setting
To adjust the Ring Tone for a line:
• Press the
• Press the digit, or move the cursor to 3. Phone Settings using the Down softkey
and press the Select softkey.
• Press the digit, or move the cursor to 2. Ring Settings using the Down softkey and
press the Select softkey.
• Dial the line number plus one (2 for Line 1, 3 for Line 2, etc.), or move the cursor to
Line n Configuration using the Down softkey and press the Select softkey. The value
of n is the line button number.
• Press the digit, or move the cursor to 1. Ring Tone using the Down softkey and
press the Select softkey.
• Select the Ring Tone using the Down softkey.
Press the Play softkey to hear the selected tone.
The Disable Ringer selection turns the ringer off for
incoming calls on the line. The Set as Default uses
the Default Ring Tone for incoming calls on the
line as specified in the previous Default Ring
Tone section.
• Press the Select softkey to save the selection.
• To configure another parameter, press the Back softkey to continue or press the
button to exit the configuration menu.
1 0
button.
button.
button to exit
T S - 3 5 0 i S T A R T G U I D E