Commissioning And Startup Of The Et 200S; Configuring The Eip-200S Ethernet/Ip Adapter; Setting The Ip Address - Siemens SIMATIC S7 EIP-200S System Manual

Commissioning and diagnostics

4.2 Commissioning and startup of the ET 200S

4.2 Commissioning and startup of the ET 200S
Software requirements
To configure the EIP-200S Ethernet/IP Adapter interface module, use the ZNX-EIP-200S
Configuration Tool software package. Refer to its documentation for information on how to
configure the system.
Requirements for commissioning the ET 200S
The requirements for commissioning the ET 200S are shown below:
● Adapter installed
● Adapter wired
● Switch on supply voltage for the Adapter
● Switch on the supply voltage for the load as necessary
● Adapter configured and parameters assigned
● Supply voltage switched on for scanner
● Scanner set to RUN mode
4.3

Configuring the EIP-200S Ethernet/IP Adapter

Use the EIP ET200 Configuration Tool to configure the EIP-200S Ethernet/IP Adapter. Refer
to the EIP ET200 Configuration Tool User Manual for complete instructions.
4.4

Setting the IP address

DHCP is the factory default. When the EIP-200S Ethernet/IP Adapter is using DHCP,
IP addresses can be set using Microsoft Windows and Linux DHCP/BOOTP servers. There
are several free servers for Microsoft Windows available for download from the Internet. Use
discretion when downloading software from the Internet.
After the IP address is set with DHCP, you can use the EIP ET200 Configuration Tool to set
a permanent IP address and turn off DHCP. See the EIP ET200 Configuration Tool User
Manual for more information.
84
EIP-200S Ethernet/IP Adapter Distributed I/O System
System Manual, 06/2018, A5E44345053-AB