Siemens SIMATIC S7 EIP-200S System Manual page 39

Control Bits operate as follows:
Bit(s)
0
1
Interface Capability
The Interface Capability attribute indicates the set of capabilities for the interface. The
attribute is a structure with two main elements: Capability Bits and Speed/Duplex Options.
Bit(s)
0
1
2
3
4-31
The Interface Capability attribute indicates the set of capabilities for the interface. The
attribute is a structure with two main elements: Capability Bits and Speed/Duplex Options.
EIP-200S Ethernet/IP Adapter Distributed I/O System
System Manual, 06/2018, A5E44345053-AB
Called:
Autonegotiate
Forced Duplex Mode
Called:
Manual Setting Re-
quires Reset
Auto Negotiate
Auto-MDIX
Manual Speed/Duplex
Reserved
2.6 Device profile: supported CIP objects
Definition
0 = 802.3 link autonegotiation is disabled.
1 = autonegotiation is enabled.
If autonegotiation is disabled, the device uses the settings indicat-
ed by the Forced Duplex Mode and Forced Interface Speed bits.
If the Autonegotiate bit is 0, the Forced Duplex Mode bit indicates
whether the interface operates in full or half duplex mode.
0 = half duplex.
1 = full duplex.
Interfaces not supporting the requested duplex return 0x09 (Invalid
Attribute Value). If autonegotiation is enabled, attempting to set the
Forced Duplex Mode bits results in a response of 0x0C (Object
State Conflict).
Definition
Indicates whether or not the device requires a reset to apply
changes made to the Interface Control attribute (#6).
0 = Indicates the device automatically applies changes made to
the Interface Control attribute (#6) and does not require a reset for
changes to take effect. This is the value this bit has when the Inter-
face Control attribute (#6) is not implemented.
1 = Indicates the device does not automatically apply changes
made to the Interface Control attribute (#6) and, requires a reset in
order for changes to take effect.
Note: this bit is also replicated in the Interface Flags attribute (#2)
to retain backwards compatibility with previous object revisions.
0 = Indicates the interface does not support link auto-negotiation.
1 = Indicates the interface supports link auto-negotiation.
0 = Indicates the interfaces does not support auto MDIX operation.
1 = Indicates the interface supports auto MDIX operation.
0 = Indicates the interface does not support manual setting of
speed/duplex. The Interface control attribute (#6) is not supported.
1 = Indicates the interface supports manual setting of
speed/duplex via the Interface Control attribute (#6).
Set to 0
EIP-200S Ethernet/IP Adapter
39