Siemens SIMATIC S7 EIP-200S System Manual page 38

EIP-200S Ethernet/IP Adapter
2.6 Device profile: supported CIP objects
Media Counters (STRUCT of)
Name
Alignment Errors
FCS Errors
Single Collisions
Multiple Collisions
SQE Test Errors
Deferred Transmission
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
Interface Control attribute
The Interface Control attribute is a structure consisting of Forced Interface Speed and
Control Bits.
If the autonegotiate bit is 0, the Forced Interface Speed bits indicate the speed at which the
interface operates. Speed is specified in megabits per second; for example, for 10 Mbps
Ethernet, the Interface Speed is 10. Interfaces not supporting the requested speed return
0x09 (Invalid Attribute Value). If autonegotiation is enabled, attempting to set the Forced
Interface Speed results in a response of 0x0C (Object State Conflict).
38
Data Type Description of Attribute
UDINT Frames received that are not an integral number of oc-
tets in length
UDINT Frames received that do not pass the FCS check
UDINT Successfully transmitted frames which experienced ex-
actly one collision
UDINT Successfully transmitted frames which experienced more
than one collision
UDINT Number of times SQE test error message is generated
UDINT Frames for which first transmission attempt is delayed
because the medium is busy
UDINT Number of times a collision is detected later than 512 bit-
times into the transmission of a packet
UDINT Frames for which transmission fails due to excessive
collisions.
UDINT Frames for which transmission fails due to an internal
MAC sublayer transmit error.
UDINT Times that the carrier sense condition was lost or never
asserted when attempting to transmit a frame
UDINT Frames received that exceed the maximum permitted
frame size
UDINT Frames for which reception on an interface fails due to
an internal MAC sublayer receive error
EIP-200S Ethernet/IP Adapter Distributed I/O System
System Manual, 06/2018, A5E44345053-AB