Supported Servers And Operating Systems; Supported Device Drivers; Specifications; Physical Specifications - IBM System Storage TS2250 Setup, Operator, And Service Manual

Supported servers and operating systems

Supported device drivers

|
|

Specifications

Physical specifications

Specification
Width
Length
Height
Weight (without a cartridge)

Power specifications

Power Measurements
AC line current
Line frequency
Line current at 100 Vac
Line current at 240 Vac
1-6
TS2250 Tape Drive Setup, Operator and Service manual
To determine the latest supported attachments, visit the web at
http://www.ibm.com/storage/lto. For specific instructions about attaching the drive,
see Chapter 2, "Installing the drive," on page 2-1.
Device drivers enable the drive to interact with a variety of servers. To properly
install an IBM device driver (if required), refer to the IBM Tape Device Drivers
Installation and User's Guide. For applications that use other device drivers, see the
application's documentation to determine which drivers to use.
IBM maintains the levels of device drivers and driver documentation for the drive
on the Internet. You can access this material at the website: http://www.ibm.com/
support/fixcentral
Note: The device driver and driver documentation for the SAS/USB drive is at
http://www.ibm.com/support/fixcentral on the TS2250 web page.
Note: If you do not have Internet access and you need information about device
drivers, contact your Marketing Representative.
Note: The device driver for System i
system.
The sections below give the physical, power, and environmental specifications for
the drive. Specifications for tape cartridges are given in "Environmental
specifications" on page 1-7.
®
servers is included in the OS/400
Measurement
213 mm (8.4 in.)
332 mm (13.1 in.)
58 mm (2.3 in.)
4.3 kg (9.4 lbs.)
Drive
100 to 240 Vac
50 to 60 Hz, auto-ranging
0.48 A
0.20 A
®
operating