Speed & Duplex - Allied Telesis 2914 Series Installation And User Manual

2914 Series Fiber Network Adapters with WoL Installation and User's Guide
Speed & Duplex
70
The Speed & Duplex property sets the link speed and duplex mode for the
copper port. For the fiber port, Auto Negotiation is specified.
Note
Because the port of the 2914 series network adapter is a fiber
connector, the setting is always Auto-negotiation.
When the system is connected to the network and power is supplied, a
network adapter attempts as follows:
The AT-2914SX/SC and AT-2914SX/LC adapters attempt to

negotiate duplex and flow control. If the link partner does not
support Auto-negotiation, the network adapter bypasses the
process and attempts to establish at 1000Mbps in full duplex.
The AT-2914SP adapter with a Gigabit SFP transceiver attempts

to negotiate duplex and flow control.If the link partner does not
support Auto-negotiation, the network adapter bypasses the
process and attempts to establish at 1000Mbps in full duplex.
The AT-2914SP adapter with a 100Mbps SFP transceiver attempts

to establish at 100Mbps in full duplex.
To view the Speed & Duplex property, do the following:
1. Access the Advanced Properties.
See "Accessing Advanced Properties" on page 51.
2. Select Speed & Duplex in the Property box.
The Speed & Duplex page is displayed as shown in Figure 34 on page
71.