Linux - Allied Telesis 2914 Series Installation And User Manual

The network connectivity information is displayed, as shown in
Figure 43.

Linux

To verify that the Ethernet interface is up and running, run 'ifconfig' to
check the status of the Ethernet interface. In addition, you can use the
'netstat -i' command to check the statistics on the Ethernet interface.
Consult the manual pages for more information about the 'ifconfig' and
'netstat' commands.
To ping an IP host on the network to verify connection has been
established, perform the following procedure.
1. From the command line, type ping <IP address>.
2. Press Enter.
The command displays the packet send/receive status.
Figure 43. Command Window with ping displayed
Chapter 6: Troubleshooting
89