Replacing The Bracket - Allied Telesis 2914 Series Installation And User Manual

2914 Series Fiber Network Adapters with WoL Installation and User's Guide

Replacing the Bracket

28
The 2914 series network adapter is shipped with the low-profile bracket
attached to the adapter. Depending on your system, you may need to
replace the bracket attached to your adapter card.
The following procedure describes how to remove the low-profile bracket
from the network adapter and replace it with the standard bracket. You
can also use this procedure to remove the standard bracket and replace it
with the low-profile bracket.
To replace the low-profile bracket with the standard bracket, perform the
following procedure:
1. Remove the screws that attach the bracket to the network adapter.
See Figure 7.
Figure 7. Removing the Low-Profile Bracket
2. Align the tabs of the standard bracket with the holes on the network
adapter and fasten the screws onto the network adapter. See Figure 8
on page 29.