2914 Series Fiber Network Adapters with WoL Installation and User's Guide
Testing Network Connectivity
Windows
88
This section describes how to test network connectivity for Windows and
Linux networks.
Note
When you are using the fiber optic port, both the adapter and the
switch must be set to the same speed and duplex mode.
To test the network connectivity for the Windows driver software, perform
the following procedure.
Use the ping command to determine if network connectivity is working.
1. Click the icon at the left bottom corner of the Windows.
2. In the search box, type cmd and click OK.
3. Type ipconfig /all
The command window opens, as shown in Figure 42.
Figure 42. Command Window with ipconfig/all displayed
4. Type ping <IP address> from the command line, then press Enter.