Federal Communication Commission Interference Statement - Allied Telesis 2914 Series Installation And User Manual

Appendix B: Regulatory Statements

Federal Communication Commission Interference Statement

94
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.
Caution
Avertissement de la FCC: Les changements ou modifications non
expressément approuvés par la partie responsable de la conformité
pourraient annuler l'autorité de l'utilisateur à utiliser cet équipement.
E80

This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
The transmission in the band from 5600MHz to 5650MHz is disabled by
the software installed on the device. You cannot change this setting. This
device meets all the other requirements specified in the Part 15E, Section
15.407 of the FCC Rules.
E80
