ABB ACH580 Series Installation, Operation And Maintenance Manual page 36

36
12. Strip and connect the individual control wires to the drive terminals. Tighten the
screws to 0.4 lb-ft (0.5...0.6 N•m).
WARNING! To avoid danger or damage to the drive on IT systems and corner
grounded TN systems, see section
and corner-grounded TN systems (North America)
Analog Inputs
and Outputs
Digital Inputs
Typical Type 1
1
Note: UDC+ and UDC- terminals are used for external brake chopper units.
Power wiring torque table
T1/U, T2/V, T3/W
ACH580-01 Installation
R5
12
EMC
VAR
6
3
8
1
Frame size
ACH580 Installation, Operation and Maintenance Manual
Checking the compatibility with IT (ungrounded)
Panel Connector
Power (Green) and
Fault (Red) LEDs
Relay
Outputs
5
Shroud
8
R5
lb-ft N•m
4.1 5.6
on page 17.
Option Mounting