Memory Channels - Kemppi A3 MIG Operating Manual

Table of Contents

4.5 Memory channels

Use the control panel memory channels to store welding parameters you use into the

machine's memory for easy use later without the need to readjust all parameters. The

control panel has 90 memory channels, numbered 0...89.

You can store the welding parameters you use, i.e., the wire feed speed and the welding

voltage. You can also store MIG feature settings, such as creep start or crater fill settings.

Storing welding parameters in memory

Press the MEMORY button (9) twice. If a memory channel is free, the SET

indicator starts flashing. In other cases, it will be turned on constantly. (If

the memory is empty, one push of the button is enough.)

Select the memory channel you want using the CH button (10).

Specify the welding settings you want and store the selections by

pressing SAVE button (11).

Press the MEMORY button (9) twice. The ON indicator light will turn on

and the welding parameters you selected are activated.

Start welding.

If you want to change the welding parameters stored in a welding channel, go to the SET

mode by pressing the MEMORY button. Now select the parameters you want and store

them by pressing SAVE.

You can also store the welding parameters with the SET button when the memory fea-

ture is in the OFF state, i.e., when the MEMORY indicators are not on.

To clear the data in a memory channel, press the MEMORY and CH buttons simultane-

ously when the control panel is in the SET mode (the SET indicator is on).

Using stored welding parameters

Press the MEMORY button to turn on the ON indicator.

Select the memory channel you want from the robot.

Start welding.

A3 MIG Welder

1826

Table of Contents