FibberservCL FSSEG-X3 User Manual page 58

Step 6: Remove the old thermostat base
Unscrew the old thermostat base from the wall, gently pull it out and ensure wires do not fall back
into the hole in the wall.
Step 7: Attach the base of the FSPCT503 Thermostat to the wall
Bundle and insert wires through the hole in the base of the FSPCT503 Thermostat, then attach the
base to the wall with the screws.
!
Step 8: Connect wires
Connect wires to the corresponding terminal in the base.
If you have installed a wiring module in step 5, use the picture to help you remember the name of
wires.
Take a picture of the wires when you are done to help you remember.
You will be asked for the wiring configuration in the setup wizard.
Step 9: Switch the DIP switch
Switch the DIP switch in the back of the thermostat to RC if you have connected both RC-wire and
RH-wire to the wall plate, otherwise switch it to the RC&RH side.
!
Step 10: Attach the FSPCT503 Thermostat to the base
Gently push the PCT503 to the base until it clicks.
Step 11: Power on your system
Turn the power back on to the Heating/Cooling system.