FibberservCL FSSEG-X3 User Manual page 17

2.2. Buttons Introduction
Rotary button
• Turn ON and OFF the LED bulb.
• Adjust the brightness of the LED bulb.
• Adjust the colour and temperature of the LED bulb.
Reset button
• Return the device to default factory settings.
• Set the device into pairing mode to pair with an LED bulb.
Release Catch
Push and turn in the direction of the arrow to remove from the back plate. This will allow battery
•
fitment and replacement.
Color Temperature/Brightness selector switch
Select colour and temperature adjustment
•
Select brightness adjustment
•
3. Get started
To get started, you will need:
A SEG-X3 Smart Gateway
•
A LED622 ZigBee CCT Tunable LED bulb
•
A SLC603 ZigBee Dimmer Switch
•
The Fiberserv mobile app
•
Then follow the steps below:
Step 1: Install the batteries
Remove the device from its back plates as described previously, fit the batteries and re-assemble.
Step 2: Check the switch status
Press the rotary button and check if the LED indicator light is flashing red.
Tip: if not, please return it to default factory settings by using a pin key tool to press and hold the
reset button for ten seconds until the LED indicator flashes twice.
!
Tip: for this step, you could also press the "Z" button of the gateway for two seconds until the LED
indicator turns solid blue.