FibberservCL FSSEG-X3 User Manual page 28

!
(4) After successful pairing, the LED bulb will stop flashing, and the corresponding status LED
indicator will flash green three times.
Tip: If pairing fails, the corresponding status LED indicator will flash red three times. If this happens
you must repeat this process again.
(5) Repeat all the steps again to bind with other LED bulbs as required.
You are now able to control the LED bulb using the remote control.
4. FAQ
Q1. How to return this device to default factory settings?
A1: Use a pin key tool to press and hold the reset button for ten seconds until the LED indicator
flashes green twice, then after you release the main LED indicator will rapidly flashes ten times.
Q2. How to restart this device?
A2: Use a pin key tool to press and hold the reset button for three seconds until the LED indicator
flashes green once.
Q3. Can I use this device to control a CCT tunable LED bulb without a gateway and the mobile
app?
A3: Yes. but the LED bulb need to be based on standard ZigBee Lighting Link profile. If you have a
ZigBee Lighting Link version CCT tunable LED bulb, please follow the steps below to use this
device to bind them together. Note: all devices need to be returned to factory default settings before
you continue.
Step 1: place the remote control near to the LED bulb, press and hold one of the individual buttons
for about three seconds until the LED flashes green three times.
Step 2: If pairing is successful, the LED bulb will flash several times.
Q4. Can I use this remote control to control LED bulbs without the help of the gateway and the
mobile app?
A4: Yes. But the LED bulb needs to be based on standard ZigBee Lighting Link profile such as
LED622. If you have LED622 bulbs, please use this device and follow the instructions below.
Note: All below devices need to return to default factory settings before you continue.
(1) Place the RC204 Remote Control near to the LED622, press and hold the one of the individual
ON/OFF buttons of the RC204 for about three seconds until the LED flashes green three times.
(2) If pairing is successful, the LED bulb will flash several times.
Refer to FCL TRAINING MANUAL - PRODUCT SPECS for Technical specifications.