FibberservCL FSSEG-X3 User Manual page 18

Step 4: Use a pin key tool to press the reset button. Then the Dimmer Switch will try to join the
gateway based system.
Step 5: Check if the Dimmer Switch is added into the gateway.
When the Dimmer Switch is added into the gateway based system successfully, the LED indicator
will be flashing green three times.
After pairing, please press the rotary button and check if the LED indicator is off indicating that it is
added into the system.
Tip: If the LED is still flashing, it means that the SLC603 Dimmer Switch hasn't added into the
gateway. You will need to repeat the process from step 2.
Step 6: Bind with the CCT Tunable LED bulb LED622
Note: please make sure the LED622 is also added into the same gateway based system and can
be controlled by the mobile app before you continue.
(1) Make sure the LED bulb is powered on.
(2) Go to the "Automation" section, tap "Edit" (Android phone) or swipe from left to right (iPhone),
tap "Identify". The LED bulb will flash during the "Identify" process.
!
(3) Press and hold the reset button of the Dimmer Switch for three seconds until green LED flashes
three times.
(4) After successful pairing, the LED bulb will stop flashing, and the LED indicator of the Dimmer
Switch will flash three times.
You are now able to control the LED bulb using the Dimmer Switch.
4. FAQ
Q1. How can I return this device to default factory settings?
A1: Please use a pin key tool to press and hold the reset button for ten seconds until the LED
indicator flashes twice.
Q2. Can I use this device to control a CCT tunable LED bulb without a gateway and the mobile
app?
A2: Yes. But the LED bulb needs to be based on standard ZigBee Lighting Link profile such as
LED622. If you have a LED622, please use this device and follow the instructions below.
Note: All the below devices need to be returned to default factory settings before you continue.
(1) Place the Dimmer Switch near to the LED622 Bulb, press and hold the reset button of the
Dimmer Switch for about three seconds until the LED flashes green three times.
(2) If pairing is successful, the LED622 bulb will flash several times.
Refer to FCL TRAINING MANUAL - PRODUCT SPECS for Technical specifications.