FibberservCL FSSEG-X3 User Manual page 14

COST SAVINGS & ENERGY EFFICIENCY
FSLED622 CCT Tunable LED Bulb
Quick Start Guide
1. Introduction
The FSLED622 ZigBee CCT Tunable LED bulb allows you to do the following from the mobile app:
• Switch it ON and OFF
Adjust its brightness
•
Adjust its colour
•
Adjust its temperature
•
Set an on/off schedule
•
2. Get started
2.1 To get started, you will need:
FSSEG-X3 Smart Gateway
•
FSLED622 CCT Tunable LED Bulb
•
The Fiberserv mobile app
•
Then follow the steps below:
Step 1: Turn OFF the light switch
Step 2: Fit the LED622 LED Bulb into the light or lamp socket.
Step 3: Turn ON the switch and check if the LED622 LED Bulb flashes twice, if so follow the below
steps, otherwise, please refer to the FAQ section.
Step 4: Turn OFF the Switch
!