FibberservCL FSSEG-X3 User Manual page 36

!
3. Get started
3.1. To get started, you will need:
• FSSEG-X3 Smart Gateway
• FSGD334 Gas Detector
• The Fiberserv mobile app
3.2 Connect to gateway's network
1. Plug the gas detector to power outlet, the LED indicator will flash alternatively for three minutes,
indicating the sensor is warming up.
2. After the LED indicator become solid green, set your gateway to permit joining.
3. The gas detector will join the gateway's network automatically. The LED light will be off and then
light up in green again indicating the gas detector has successfully joined the gateway's network.
4. Now you can see the gas detector under "Security" in the mobile App.
3.3 Mounting instructions
Before installation, please confirm whether the gas density is heavier or lighter than the air.
If the gas is heavier than the air, such as LPG, etc, install at 0.3-1m height from floor, less than 1.5m
from the gas source. If the gas is lighter than air, such as natural gas, manufactured gas, marsh
gas, etc, install at 0.3-1m height from ceiling, less than 1.5m from the gas source.