FibberservCL FSSEG-X3 User Manual page 57

!
2. Disconnect the R/RC, W-O/B, Y, G wires form the control board and reconnect them
correspondingly to the 4 terminals side of the wiring module.
For Y-wire and G-wire, you can connect the Y-wire to S-terminal, G-wire to C terminal, then
change the label of the Y-wire to the S-wire, the G-wire to the C-wire.
Take a picture of your wires with new labels to help you remember.
3. Generally the control board will have R, G, Y, W, C terminal, connect the pre-wired side of the
wiring module (5 terminals) to the corresponding terminals.
!