Table of Contents
Advertisement
LIFE SAVING/AVOID MAJOR DISRUPTIONS
!
FSGD334 Gas Detector
Quick Start Guide
1. Introduction
The Gas Detector uses an extra low power consumption ZigBee wireless module.
It is used for detecting combustible gas leakage.
Also it can be used as a ZigBee repeater that extends wireless transmission distance.
The gas detector adopts high stability semi-conductor gas sensor with little sensitivity drift.
2. Get to know your device
2.1. FSGD334 at a glance
!
Reset button
Reset. Press and hold the reset button for five seconds until the LED indicator flashes green six
times to reset to default factory setting.
Test button
Test. Press the test button to enter test mode. The LED indicator will flash three times and the
alarm will beep three times.
Advertisement
Table of Contents
