Removing The Rear Access Panel - Whirlpool WFC8090GX Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Rear Access Panel
1. Unplug washer or disconnect power.
2. Turn off water supply to washer.
3. Disconnect cold inlet water hose and remove the drain
hose from the standpipe or laundry tub.
4. Remove six (6) Phillips screws securing the rear access
panel to the back panel as indicated in Figure 1. Remove
rear access panel.
Remove 6 Screws

Removing the Rear Access Panel

Figure 1
Whirlpool Smart All-In-One Washer & Dryer
COMPONENT ACCESS
n
4-7