Whirlpool WFC8090GX Service Manual page 73

Removing the Direct Drive Motor (continued)
6. While the rotor is blocked, use a ratchet and a 5/8" hex
head bit to loosen the rotor bolt as shown in Figure 4.
NOTE: The same procedure must be performed when
reattaching the rotor during reinstallation.
7. After the rotor screw is removed, push the wash unit
towards the front and lock in place with a 2 x 4 or wood
block. This allows for room to remove the rotor.
8. Remove the rotor from the stator by pulling it backwards.
9. Unplug the motor connector from the MCU.
10. Use a Phillips screwdriver to remove the six (6) clamp
screws securing the motor harness to the back of the tub.
11. Remove any additional harness clips (push mount wire
ties) that may be securing the motor harness.
Figure 4
12. Use a T-30 Torx socket to remove the six (6) stator bolts as
illustrated in Figure 5. Remove the stator assembly.
IMPORTANT: Be sure to protect the rotor and stator from dust
or debris during disassembly and reassembly. Debris on the
rotor or stator can damage the motor during operation.
Whirlpool Smart All-In-One Washer & Dryer
COMPONENT ACCESS
Figure 5
4-21
n