Cleaning The Drain Pump Filter/Draining Residual Water - Whirlpool WFC8090GX Service Manual

GENERAL INFORMATION

Cleaning the Drain Pump Filter/Draining Residual Water

Cleaning the Drain Pump Filter/
Draining Residual Water
WARNING
Electrical Shock Hazard
CLEANING THE DRAIN PUMP FILTER/
Disconnect power before cleaning.
DRAINING RESIDUAL WATER
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER
corner at the front of the washer/dryer.
NOTE: Perform the following procedure every 6 months.
1. Open the drain pump lter access door at the bottom right
corner at the front of the washer/dryer.
to collect the drain water. Pull out the black hose, remove
the plug, and drain the hose into the container. Empty
the container. Repeat this procedure if necessary until all
2. Place a broad, at container beneath the drain pump lter
the water has drained. Make sure that the black hose is
to collect the drain water. Pull out the black hose, remove
completely dry.
the plug, and drain the hose into the container. Empty
the container. Repeat this procedure if necessary until all
the water has drained. Make sure that the black hose is
Black hose
completely dry.
Black hose
n
1-12 Whirlpool Smart All-In-One Washer & Dryer
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER (cont.)
CLEANING THE DRAIN PUMP FILTER/
3. Lay a cotton cloth beneath the drain pump lter to absorb
any water still in it. Then remove the drain pump lter by
DRAINING RESIDUAL WATER (cont.)
turning it counterclockwise.
3. Lay a cotton cloth beneath the drain pump lter to absorb
any water still in it. Then remove the drain pump lter by
turning it counterclockwise.
4. Remove large clumps of lint by hand from the lter and
place lint in a suitable waste container. Remove remaining
residue from the lter by rinsing with water.
4. Remove large clumps of lint by hand from the lter and
place lint in a suitable waste container. Remove remaining
residue from the lter by rinsing with water.
5. Reinsert the drain pump lter by turning it clockwise.
Make sure to turn it in as far as it will go, with the lter
handle left in a vertical position.
5. Reinsert the drain pump lter by turning it clockwise.
Make sure to turn it in as far as it will go, with the lter
handle left in a vertical position.