Removing The Access Panel - Whirlpool WTW9500E SERIES Service Manual

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.

Removing the Access Panel

1. Unplug washer or disconnect power.
2. Turn off water supply to washer.
3. Remove three (3) 1/4" hex-head mounting screws from
the rear of the access panel as indicated in Figure 1.
NOTE: The screws should remain attached to the access
panel.
4. Lift up panel slightly from the rear and remove from
washer.
Remove three 1/4" hex head screws
n
4-4 2016 Cabrio & Bravos Top Load, Direct Drive Washer
Removing the Access Panel
Figure 1
5. Once the panel is removed, you have access to the main
control, relay expansion board (if equipped), water valve
assembly, and lid hinges (see Figure 2).
Figure 2