Replacing The Human-Machine Interface - Whirlpool WFC8090GX Service Manual

COMPONENT ACCESS
Replacing the Human-Machine Interface (HMI)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Replacing the HMI
IMPORTANT:
The WiFi Board is incorporated into the HMI. If the HMI is
replaced and the appliance was previously connected to the
customer's Home Area Network (HAN), the washer/dryer must
be re-provisioned (reconnected) to the customer's HAN and
added to the customer's account on the Whirlpool App.
An extra SAID & MAC Sticker is provided with the service
replacement HMI. Be sure to place the replacement sticker
over the existing sticker on the upper door cover. See Figure 2.
Figure 1 - HMI, Front View
4-4 Whirlpool Smart All-In-One Washer & Dryer
n
1. Unplug washer/dryer or disconnect power.
2. Perform the procedures on page 4-2 "Removing the Door
Assembly" prior to performing the following steps.
3. Locate a suitable work surface and lay a soft towel down
to protect the door. Place door, front side down, on
towel.
4. Using a Phillips screwdriver, remove the five (5) screws
indicated in Figure 2. Remove the upper door cover and
set aside.
SAID & MAC
Sticker
Figure 2 - Opper Door Cover
5. Using a Phillips screwdriver, remove the six (6) "lower"
inner door screws, the two (2) catch screws, and the three
(3) hinge screws indicated in Figure 3. Remove "lower"
inner door panel and set aside for reassembly.
Door
Strike
Inner Door
Hinge & HMI
Harness
Figure 3
Panel