COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Door Assembly
1. Unplug washer or disconnect power.
2. Open door and remove the two (2) hinge screw covers
illustrated in Figure 1.
3. Using a Phillips screwdriver, remove the two door hinge
cover screws. Remove door hinge cover and set aside.
4. Pull out the HMI connector bag from below door hinge
(see Figure 2 & 3). (The bag is "tucked-away" between
the hinge and front panel.) Remove tape and bag, and
disconnect HMI connector. Preserve the tape and bag for
reassembly.
4-2
Whirlpool Smart All-In-One Washer & Dryer
n
Removing the Door Assembly
Figure 1
Remove HMI
Connector Bag
Figure 2
5. Remove tape and bag, and disconnect HMI connector (see
Figure 4). Preserve the tape and bag for reassembly.
HMI
Connector
6. Using a 10 mm hex head driver,
remove three (3) hinge screws.
See Figure 5 at right.
7. Lift up on door assembly and
remove.
8. Reverse procedure to reinstall.
Be sure to reinstall the HMI
connector bag and tape.
Figure 3 - Connector Bag
Figure 4
Remove 3
Hinge Screws
Figure 5