13. FITTING & REMOVING THE INTERCOM FRONT
Before fitting the intercom front; set the Address and Options DIL switches and check links LK1‐3 are fitted in the correct
positions. Ensure all cables are properly terminated and secure spare wires in the clips provided.
FITTING THE INTERCOM FRONT
Locate the 2 top corners of the intercom front over the 2 top corners of the intercom back, swing downwards and clip
together ensuring the pullcord is located in its slots.
BASE FIXED TO WALL
LOCATE TOP TWO CLIPS FIRST
SWING
DOWNWARD
AND CLIP
TOGETHER
REMOVING THE INTERCOM FRONT
Use the pegs on the orange triangle to push the clips one at a time on the lower face whilst pulling the front outwards from
the bottom edge.
LIFT LID
OUTWARDS
FROM
LOWER EDGE
INSERT THE TRIANGLE PEGS
INTO THE BASE CLIPS.
APPLY MORE FORCE TO
ONE PEG, WHILE GENTLY
LIFTING THAT SIDE OF THE LID.
THEN APPLY FORCE TO THE
OTHER CLIP, SIMULTANEOUSLY
LIFTING THE LID.
Doc No. FM0410 issue M‐1 Page 20
NOTE
ENSURE THE PULLCORD
IS LOCATED IN THESE
SLOTS
ALWAYS CHECK THE PULLCORD OPERATES
AFTER THE FRONT IS FITTED